A week away in July can turn a pool green. A week away in December usually won't. In a Placer County winter, the real risk is the storm that hits while nobody's home.
Cold water is forgiving. Chlorine lasts longer, algae grows slowly, and a balanced pool can sit for a week or two without much trouble.
The problems we find after holiday trips usually aren't about the water. They're about something that stopped running while the house was empty: a tripped breaker, an outage on a cold night, a skimmer packed with leaves, or a hot tub someone unplugged to be safe.
This winter raises the odds. Placer County's El Niño page says the National Weather Service outlook calls for above-average rain here this season. Here's what to do before you leave, who should check on things while you're gone, and what to look at when you get back.
Is It Safe to Leave Your Pool Alone in Winter?
For a week or two, usually yes, as long as the equipment keeps running.
In summer, a week of neglect can be enough, which we covered in why pool water turns green so fast. Winter is slower. Most unheated pools here are already in the 50s, and algae doesn't do much in water that cold.
What changes in winter is everything that can stop the equipment. Storms knock out power and trip breakers. Leaves fill the baskets until the pump can't pull water. And a pump that isn't moving water can't protect itself on a freezing night. According to the UC Master Gardeners of Placer County, the coldest night of a typical winter in western Placer County lands somewhere between 20 and 30 degrees.
What Should You Do to Your Pool Before You Leave?
Give it an hour, a day or two before the trip.
Test the water and set chlorine toward the upper end of your normal range. CDC recommends at least 1 ppm of free chlorine in a pool, so don't leave it sitting near the minimum. Get pH in range too.
If you have a salt system, add liquid chlorine before you go. Most salt cells shut off once the water drops into the low 50s, which we explain in why your saltwater pool stops making chlorine in winter.
Empty the skimmer and pump baskets. During heavy leaf drop they can fill back up in a few days. Here's why skimmer baskets need attention on repeat.
Check the filter pressure, and clean the filter if it's running high. Here's why filter pressure keeps climbing.
Set the water level at the middle of the skimmer opening. Don't drop it lower to make room for rain. If the level falls below the skimmer, the pump can start pulling air.
Leave the pump on its normal winter schedule and the breaker on. Shutting everything off causes more trouble than anything else on this list, as we explain in do you need to winterize your pool.
Make sure freeze protection is turned on. If a second pump runs a waterfall or spillover spa, check that freeze protection is set for that pump too.
If your pool has an automatic fill, think about turning it off while you're gone. Winter rain will top the pool up, and a fill valve that sticks open can run for days with nobody home to notice.
Put pool chemicals away, sealed and out of the rain.
What Should You Do With Your Hot Tub?
Leave it on. This is the mistake we see most often.
Most hot tubs have built-in freeze protection that runs the pump when it gets cold, but it only works if the spa has power. An unplugged spa, or one with the breaker off, has no way to protect itself on a freezing night. Draining it doesn't fix that either. A drained spa still holds water in its pump, heater, and plumbing.
Instead:
Use the economy, away, or vacation mode if your spa has one. On ThermoSpas hot tubs, for example, economy mode lets the water drift down to 15 degrees below the set temperature. Your manual will say what yours does.
Test and sanitize before you leave. CDC recommends at least 3 ppm of free chlorine in a hot tub.
Clip every strap on the cover. A strapped cover stays put in the wind and keeps out leaves, rain, and neighborhood kids.
Hosting before or after the trip? See getting your hot tub ready for holiday guests.
Who Should Check on Things While You're Gone?
Someone should, especially after a big storm.
If you're on weekly pool service or spa service with us, tell us your travel dates. That way we know the house is empty and can call you if something looks wrong.
If you're not, ask a neighbor to take a five-minute look after any heavy rain or wind:
No standing water at the equipment pad
Pool water not up over the skimmer opening
Skimmer basket not packed with leaves
Spa cover on, with the straps clipped
Tell them what not to do, too. They shouldn't reset a breaker more than once, and they shouldn't touch equipment that has been sitting in water. Give them our number, (916) 975-7370, so they can call us instead. Our post on protecting your equipment from El Niño storms has the full after-storm checklist.
How Can You Tell If the Power Went Out While You're Away?
Set up outage alerts for your address before you leave.
An outage is the biggest risk to an empty house in storm season. When the power goes out, the pump stops, freeze protection stops, and the spa starts cooling down. Placer County has seen this before. In the February 2024 storm, Placer County was PG&E's biggest outage area, with more than 41,000 customers still without power the next morning.
Most of our area, including Lincoln, Rocklin, Granite Bay, Loomis, Penryn, and Sheridan, is on PG&E. If your phone number is on your account, you can text "Status" to 97503 for the outage status at your address. PG&E explains how to set up outage alerts here.
Roseville homes are on Roseville Electric, which has an outage map and text notifications.
If your pool automation has a phone app, check it once a day. If it shows the system offline during a storm, the power may be out at the house.
When the power comes back, a mechanical timer will be off by however long the outage lasted, so the pump runs on the wrong schedule until someone resets it. If the breaker trips again once power returns, leave it off and read why pools and spas keep tripping the breaker.
Which Parts of Placer County Need Extra Attention?
The basics are the same everywhere. A few things change from one area to the next.
Penryn and Loomis have a lot of oaks and pines near power lines, so wind storms tend to knock out power more often. Outage alerts and freeze protection matter most here.
In Granite Bay, big oaks keep dropping leaves into December, and larger custom pools often have waterfalls or spillover spas on their own pumps. Empty the baskets the day you leave, and make sure freeze protection covers every pump.
In Sheridan, flat rural lots can hold standing water around the equipment pad, and a lot of pools run older equipment. Check that rain drains away from the pad before you go. On well-water properties here and in Loomis and Penryn, turning off an automatic fill also keeps extra iron and minerals out of the pool while you're away.
In Lincoln, Rocklin, and Roseville, equipment pads often sit in narrow side yards where roof runoff collects. Make sure the downspouts aren't draining onto the pad.
What Should You Check When You Get Home?
Start at the equipment pad, before anyone gets in the water.
Look for standing water, a tripped breaker, or water inside the spa cabinet. If equipment sat in water, leave it off and call for a pool repair or spa repair.
Make sure the pump runs and the timer shows the right time.
Empty the baskets, check the water level, and check the filter pressure.
Test and rebalance the water. If it's green or cloudy, start with why pool algae keeps coming back.
Switch the spa back to its normal mode a day before you want to use it, since heating back up takes a while. If it won't heat, see why your pool or spa won't heat.
Turn the automatic fill back on if you shut it off.
Quick Answers
Should I turn off my pool pump when I travel in winter? No. Leave it on its normal winter schedule, with freeze protection on and the breaker on. A pump that's off can't move water on a freezing night, and the pool goes unfiltered the whole time you're away.
What should I do with my hot tub when I go out of town in winter? Leave it powered on, switch it to economy or vacation mode if it has one, sanitize the water, and strap the cover down. A hot tub's freeze protection only works when it has power.
How much chlorine should I leave in my pool before a trip? Set it toward the upper end of your normal range before you leave. CDC recommends at least 1 ppm of free chlorine in pools and at least 3 ppm in hot tubs. Salt pools usually need liquid chlorine in winter, since most salt cells shut off in cold water.
What happens to my pool if the power goes out while I'm away? The pump, freeze protection, and spa heater all stop until the power comes back, and a mechanical timer will be off afterward. Sign up for your utility's outage alerts and have someone check the equipment after big storms.
Can I leave my pool for two weeks in the winter? Usually, if the water is balanced, the baskets are empty, the equipment keeps running, and someone checks on it after storms. Cold water slows algae, so the bigger risk is equipment that stops running.
For more answers about our service, see our pool and spa service FAQ.
Heading Out for the Holidays?
American Dream Pool & Spa Service is based in Lincoln. We provide weekly pool service and spa service, along with pool repairs and spa repairs, for homeowners in Lincoln, Rocklin, Roseville, Granite Bay, Loomis, Penryn, and Sheridan. Our free Fall and Winter Pool and Spa Care Guide covers the rest of the season.
If you're leaving soon and want someone to look over your pool and spa before you go, call or text us at (916) 975-7370, or click the button below.

